Anycubic Kobra 4: ACE 2 Pro inclusion and the TPU 95A boundary

Bundle contents and material support are different checks

Confirm that the order is the Combo before expecting the named feeder. For a TPU 95A project, do not proceed through ACE 2 Pro merely because the material is sold as printer filament. Consult the model’s official material instructions for any supported alternative route; the exclusion alone does not supply that procedure.

Anycubic Kobra 4 has the following documented tpu feed constraint: TPU 95A cannot use ACE 2 Pro. Separate the printer’s material route from the optional feeder’s route. For the documented arrangement, check which unit is required, which combinations are allowed and any excluded materials before buying an expansion package. A channel or color-capacity statement describes a configuration; it does not by itself establish that a different generation’s hardware, cable or hub can be substituted.

Anycubic · store.anycubic.com

Size the setup around the chosen package

The printer is specified at 455.4 × 445.3 × 461.3 mm with a 260 × 260 × 260 mm print envelope. Those printer dimensions are not a complete claim about every feeder arrangement. The nozzle and bed limits are 300 °C and 100 °C; keep them separate from the chosen material profile and its feed restrictions.

Anycubic Kobra 4 has the following documented build volume: 260 × 260 × 260 mm. The same configuration lists printer dimensions as 455.4 × 445.3 × 461.3 mm. A usable build volume sets the boundary for the object you plan to print. Compare the part in its intended orientation with this envelope before choosing the machine. This measurement is different from the printer’s outside dimensions: fitting the printer on a desk does not establish that a particular part fits inside it.

Anycubic Kobra 4 has the following documented nozzle temperature limit: 300 °C. A hotend temperature ceiling is an operating limit, not a complete material-compatibility list or the setting for every print. Read it alongside this model’s documented filament guidance, nozzle configuration and print profiles. The maximum alone does not establish that an enclosure-dependent, abrasive or otherwise restricted material has been approved for this configuration.

Anycubic Kobra 4 has the following documented bed temperature limit: 100 °C. The same configuration lists nozzle temperature limit as 300 °C. Treat the bed limit separately from the hotend limit and the installed print surface. Those entries answer different questions, so a higher nozzle maximum does not automatically give the bed or surface the same capability. Use the documented material and surface combination when selecting a print profile rather than treating the maximum as a universal adhesion setting.

Anycubic Kobra 4 has the following documented printer dimensions: 455.4 × 445.3 × 461.3 mm. The same configuration lists build volume as 260 × 260 × 260 mm. Use the documented dimensions to plan the physical installation, retaining the exact configuration and measurement conditions. Allowing for the stated machine outline is a starting point; confirm access for the documented loading, removal and maintenance tasks before committing to a tightly fitted location.

Anycubic · store.anycubic.com