Anycubic Photon P1 Max: plan the 285.5 × 214 mm print layout

Check the full layout in the named slicer

Photon Workshop is the named manufacturer software, with a published layer range of 0.02–0.15 mm. Select P1 Max and inspect the intended model and support layout inside its own envelope. The larger area does not establish a particular batch yield, production speed or exposure time for the chosen resin.

Anycubic Photon P1 Max has the following documented build volume: 285.5 × 214 × 300 mm. The same configuration lists printer dimensions as 430 × 414 × 625 mm. A usable build volume sets the boundary for the object you plan to print. Compare the part in its intended orientation with this envelope before choosing the machine. This measurement is different from the printer’s outside dimensions: fitting the printer on a desk does not establish that a particular part fits inside it.

Anycubic Photon P1 Max has the following documented manufacturer slicer: Photon Workshop. The same configuration lists build volume as 285.5 × 214 × 300 mm. Use the named software and transfer route for the actual configuration documented here. Sending a file, preparing a sliced job and controlling the device are different steps; availability of one route does not confirm every other function. Check the manufacturer’s version and interface conditions before moving a workflow from a neighboring model or an older installation.

Anycubic Photon P1 Max has the following documented listed layer-height range: 0.02-0.15 mm. Read the layer-height range as a documented setup parameter, keeping the process and hardware configuration attached to it. It is not a measured dimensional-accuracy result or a guarantee that every model prints successfully at either end of the range. Choose the profile and material instructions for this machine, then assess whether that workflow answers your part’s actual requirements.

Anycubic · store.anycubic.com

Order consumables by model, not just the NFEP label

The NFEP description does not confirm that a film kit for another Photon fits P1 Max. Match the full model to the official replacement listing and follow its instructions. For placement, start from the body dimensions and consult the installation guidance for the space needed to use and access the machine.

Anycubic Photon P1 Max has the following documented listed release film: NFEP. The same configuration lists build volume as 285.5 × 214 × 300 mm. Use the exact model’s consumable designation when checking a replacement tank, release film or other resin-side component. A general resin-printer label does not establish fit across generations. Retain any orientation or installation warning in the linked manufacturer instructions; the existence of a replacement part is not permission to alter the documented assembly method.

Anycubic Photon P1 Max has the following documented printer dimensions: 430 × 414 × 625 mm. The same configuration lists build volume as 285.5 × 214 × 300 mm. Use the documented dimensions to plan the physical installation, retaining the exact configuration and measurement conditions. Allowing for the stated machine outline is a starting point; confirm access for the documented loading, removal and maintenance tasks before committing to a tightly fitted location.

Anycubic · store.anycubic.com