Anycubic Photon Mono 4 Ultra: ACF film and the Ultra configuration

The film designation belongs to this configuration

Anycubic names Photon Workshop as its slicer. Select the Ultra machine configuration, then use the relevant resin instructions rather than inheriting a profile from a similarly named printer. The ACF material label does not independently confirm the dimensions, frame or replacement procedure for a particular film kit.

Anycubic Photon Mono 4 Ultra has the following documented listed release film: ACF. The same configuration lists build volume as 153.4 × 87 × 165 mm. Use the exact model’s consumable designation when checking a replacement tank, release film or other resin-side component. A general resin-printer label does not establish fit across generations. Retain any orientation or installation warning in the linked manufacturer instructions; the existence of a replacement part is not permission to alter the documented assembly method.

Anycubic Photon Mono 4 Ultra has the following documented manufacturer slicer: Photon Workshop. The same configuration lists build volume as 153.4 × 87 × 165 mm. Use the named software and transfer route for the actual configuration documented here. Sending a file, preparing a sliced job and controlling the device are different steps; availability of one route does not confirm every other function. Check the manufacturer’s version and interface conditions before moving a workflow from a neighboring model or an older installation.

Anycubic · store.anycubic.com

Layer height and machine height are different decisions

The listed layer-height range is 0.02–0.15 mm, while the machine is 231 × 236 × 430 mm. Use the layer range within the selected resin profile, and check the printer location against the physical dimensions. Neither a fine layer setting nor the Ultra name is an independent print-accuracy result.

Anycubic Photon Mono 4 Ultra has the following documented build volume: 153.4 × 87 × 165 mm. The same configuration lists printer dimensions as 231 × 236 × 430 mm. A usable build volume sets the boundary for the object you plan to print. Compare the part in its intended orientation with this envelope before choosing the machine. This measurement is different from the printer’s outside dimensions: fitting the printer on a desk does not establish that a particular part fits inside it.

Anycubic Photon Mono 4 Ultra has the following documented printer dimensions: 231 × 236 × 430 mm. The same configuration lists build volume as 153.4 × 87 × 165 mm. Use the documented dimensions to plan the physical installation, retaining the exact configuration and measurement conditions. Allowing for the stated machine outline is a starting point; confirm access for the documented loading, removal and maintenance tasks before committing to a tightly fitted location.

Anycubic Photon Mono 4 Ultra has the following documented listed layer-height range: 0.02-0.15mm. Read the layer-height range as a documented setup parameter, keeping the process and hardware configuration attached to it. It is not a measured dimensional-accuracy result or a guarantee that every model prints successfully at either end of the range. Choose the profile and material instructions for this machine, then assess whether that workflow answers your part’s actual requirements.

Anycubic · store.anycubic.com